Cisco packet tracer router configuration

#Cisco packet tracer router configuration software

To prevent console messages from interrupting commands, use the logging synchronous command.

Assign cisco as the console password, configure sessions to disconnect after six minutes of inactivity, and enable login.

Generate a set of crypto keys with a 1024 bit modulus.

R2 (config)# usern ame SSHadmin secret 55 Hadm!n

Configure the username SSHadmin with an encrypted password of 55 H a dm !n.

Disable DNS lookup to prevent the router from attempting to translate incorrectly entered commands as though they were host names.

Set the domain name of the router to.

Configure c1sco1234 as the encrypted privileged EXEC mode password.

Assign a device name of R2 to the router.

Configure the IPv4 and IPv6 addresses on PC4 as listed in the Addressing Table.

Configure the IPv4 and IPv6 addresses on PC3 as listed in the Addressing Table.

Instructions Part 1: Configure Devices and Verify Connectivity Step 1: Configure the PC interfaces. For review purposes, this lab provide s the commands necessary for specific router configurations. In Part 2, y ou will use SSH to connect to the router remotely and utilize the IOS commands to retri eve information from the device to answer questions about the router.

In Part 1, you will complete basic configurations and interface settings on the router. This is a comprehensive review of previously covered IOS router commands. The R1 router and the devices connected to it have been configured.

This activity requires you to configure the R2 router using the settings from the Addressing Table and the specifications listed.

#Cisco packet tracer router configuration software

Retrieve hardware and software information from the router.

Assign static IPv4 and IPv6 addresses to the PC interfaces.

Part 1 : Configure Devices and Verify Connectivity